2. nce the options are incorrectly selected, the LEDs at panel may become blinking
after printing. Please refer to the trouble-shooting section to correct the errors.
O Selects Options
3. For X series the thermal transfer and direct thermal are set via DIP switches, not by
this command.
Syntax O[D,C,N]↵
Description This command is used to select various printer options. In
general, it depends on the configuration of your printer.
Parameters D: Enable Direct thermal (without ribbon).
C: Enable cutter.
N: Enable dispenser.
Every time when the printer is started up, the defaults
are cutter disabled, and dispenser disabled.
Example O↵ ; thermal transfer, disables cutter
and dispenser
OD↵ ; direct thermal, disables cutter and
; dispenser
OC↵ ; thermal transfer, enables cutter and
; disables dispenser
Notes:
1. The cutter and dispenser cannot be enabled at the same time.
44
43
Comments to this Manuals