Argox X-2300E User's Guide download pdf (Page 31)

Ethernet Printer Technical Manual November 10, 2010

9. Reboot Ethernet Card

When the Ethernet card is not functioning normally, we can restore its default settings by following

these steps:

1. Turn off the printer and remove all the printer covers.

2. Press and hold the RESET button, then turn on the printer. After 3 seconds, release the RESET

button. At this time, the Ethernet card enters the boot loader mode and only the Green LED lights

on.

3. You can check whether the Ethernet card enter the boot loader or not by sending the DOS

command – ping 192.168.1.100.

4. Download the Ethernet card firmware by entering tftp –i 192.168.1.100 put ARGOX_v0.71. Wait

for 40 seconds to let the Ethernet card automatically restart or until the Amber LED blinks and the

Green LED lights on. (ARGOX_v0.71 is the Ethernet card firmware and it should be placed at the

corresponding working directory).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 50 51

No comments

Argox X-2300E User's Guide Page 31